- Multi-purpose furnace developed to light-cure all composites sensitive to light currently used in the dental field, both those intended for aesthetic restorations and those produced with 3D printing system
- Ideal combination of 24 UV LEDs in different colours, emitting wide spectrum rays (ranging from 350 nm – violet to 500 nm – blue) which will activate the chemical reaction with any kind of photo-activator
- A special collimation lens concentrates the light emitted by each individual LED thus considerably increasing efficiency
- 3 circuits 8 LEDs each, arranged in a winding and focused section over the rotating plate
- 3 circuits 8 LEDs each, arranged in a winding and focused section over the rotating plate
- Timer-controlled working options: UV high spectrum only, UV low spectrum only or both combined emissions, available under vacuum, too
- Possibility to carry out the pre-lightcuring under consecutive steps of few seconds (endless step numbers with automatic start)
- Storage of different working programs
- Polished working chamber and plate with mirror effect assuring the best light refraction
- The front opening of the wide drawer gives free access to the working chamber allowing to position easily the elements to be treated
- Rotating turntable working on continuous cycle to assure the all-over exposure of bigger elements, too
- UV lighting sources 2 circuits 8 LEDs (SMD high power) with higher spectrum à 410nm and a lower one 405mn, both pointing and focusing on the geometrical centre of the table (different configurations available upon request)
- Line voltage 230v AC – 50/60 Hz
- Absorption W 250
- Fuse Amp 6.3
 |
270 x 320 x 300 mm |  |
8.5 kg |
